rootpwn

high · CVSS v3 7.1

CVE-2026-93156

In the Linux kernel, the following vulnerability has been resolved: crypto: rk3288 - fail ahash requests on HASH idle ti…

Description

In the Linux kernel, the following vulnerability has been resolved: crypto: rk3288 - fail ahash requests on HASH idle timeout rk_hash_run() waits for RK_CRYPTO_HASH_STS to become idle after the final DMA transfer, but ignores the poll result. If the hash engine never becomes idle, the driver still reads the digest registers and finalizes the request with the previous success value. Store the poll result and finalize the request with the timeout error before reading the digest registers.

Scores

Severity
high
CVSS v2
2.1
CVSS v3
7.1
CVSS v4
—
EPSS
—

← All CVEs

Related CVEs

high

CVE-2026-93203

A race condition in the batman-adv kernel module can corrupt the CRC used to validate claim frames, leading to incorrect routing information in mesh networks. The flaw may cause routing tables to become inconsistent, potentially disrupting network connectivity.

View analysis

high

CVE-2026-93117

A use‑after‑free flaw in the Linux kernel’s USB subsystem could be triggered when a USB device probe runs concurrently with the removal of a dynamic ID. The issue allows an attacker to potentially cause a crash or gain elevated privileges by manipulating USB devices during the probe phase.

View analysis

high

CVE-2026-93120

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: configfs: fix out-of-bounds read of qw_sign os_desc_qw_sign_show() passes OS_STRING_QW_SIGN_LEN as the input length to utf16s_to_utf8s(), but that argument counts UTF-16 code units while OS_STRING_QW_SIGN_LEN (14) is the byte size of qw_sign[]. The array holds only OS_STRING_QW_SIGN_LEN / 2 (7) code units, so the conversion reads up to 7 units (14 bytes) past the end of qw_sign[] into the following members of struct gadget_info when the stored signature fills the array without a NUL terminator, exposing those bytes through the configfs attribute. The store path halves the count for its input bound but passes the full byte count as the utf8s_to_utf16s() output limit; use the destination code-unit count in both directions.

View analysis

high

CVE-2026-93123

In the Linux kernel, the following vulnerability has been resolved: serial: qcom-geni: do not advance stale DMA completions The qcom GENI serial DMA TX completion path advances the transmit fifo by the number of bytes recorded in port->tx_remaining. If uart_flush_buffer() runs after the hardware has completed a DMA transfer but before the DMA completion interrupt has been handled, the serial core resets the transmit fifo while port->tx_remaining still describes the old DMA transfer. A previous fix avoided advancing an empty fifo by checking that the fifo length is at least tx_remaining. That still does not distinguish the old DMA payload from new bytes written after the flush. If userspace writes new data before the stale DMA completion interrupt is handled, the fifo can again contain at least tx_remaining bytes and the stale completion can advance and discard those new bytes. Mark an in-flight DMA transfer stale when the transmit fifo is flushed. The later completion still unprepares the original DMA mapping using the saved length, but it no longer advances the transmit fifo.

View analysis